Port-A-Cool® Maintenance

WINTERIZE YOUR PORT-A-COOL® UNIT

With the arrival of cooler weather, now is the time for owners of Port-A-Cool® units to prepare for cold weather storage of Port-A-Cool® units. Correct storage is fundamental to keep Port-A-Cool® units operating at top performance when needed.

FOUR STEPS TO STORAGE

1. Drain all water from the sump tank and clean, ensuring that the pads and sump are completely dry.
2. Clean out the in-line strainer. Remove the spray bar and clean out any debris. Reinstall after cleaning.
3. Disconnect and roll up any electrical power cords and any hoses so that they will not be trampled on, tripped over or caught in equipment.
4. Cover the Port-A-Cool® unit completely to prevent dust build-up and store the unit in a dry area. This also helps prevent damage to the pads for longer pad life. Covers are available to fit each size unit. Please visit accessories page for more information.

SUMMERIZE YOUR PORT-A-COOL® UNIT

By performing the following simple steps, a Port-A-Cool® unit will continue to produce effective cooling throughout the summer.

1. Inspect cooling media for break down, such as sagging or gapping. Clean if dirty. Replace if needed.
2. Check the fan blade to make sure it rotates freely.
3. Make sure the fan belt is tight and in good condition.
4. Oil the motor if necessary.
5. Check and clean Inline Strainer.
6. Clean Sump Tank and Spray Bar.
7. Pump should be clear of any obstructions.
8. Make sure Drain Valve is closed and spray Bar Adjustment Valve is open (approximately 3 turns).
9. Determine if water and power source are adequate.
10. Fill reservoir before turning pump “on.”
11. Make sure Float Valve operates properly.

For further maintenance instructions, please refer to the Owner's Manual that was shipped with your unit.